You
are buying a Brand New Turborix 25A Brushed Motor Electronic Speed Controller.
It is great for small to large parkflyers. It can drive brushed (DC) motors
up to 480 (280, 350, 370, 400 and 480) with ease. If you build and fly
many parkflyers, your may wish to buy a few of these as you can't find
a ESC at such a bargain price.
This
ESC is perfect for scale planes, as it operates in a scale like manner.
The motor starts when you press the button and will only shut down when
the voltage level drops below 5 volts. So cutting off the throttle lets
you idle the motor, simulating a real airplane engine (or glow engine).
You
should install the button on the side of the plane, where you can press
it just before launching your plane.
Once
you start the motor by pressing the arming button, the motor will not
stop until the battery voltage falls under 5v - cutting the throttle will
have the motor rotating at low rev. simulating engine idling.
Features:
 |
Weight:
about 15 grams with wires, plugs and switch |
 |
Current:
Continuous current rating of 25A (Max. short burst of 50A) |
 |
Input
Voltage: 7.2-12v |
 |
Features:
Battery Eliminator Circuit (BEC) to power receiver and up to 3 micro/mini
servos, |
 |
Throttle
control: Liner |
 |
Safety:
Arming switch (press to start motor)
Automatic cut off: 6v to leave enough power for the radio to allow
for a safe landing |
 |
Perfect
for 7/8 NiCad/NiMh cells or 2 LiPol cells
Ideal for motors up to size 480 type motors |
 |
Size:
Fits in to a 28x13mm opening that is 20mm deep |
 |
Servo
Connector (suits JR, Hitec, Futaba etc.) |
 |
Power
Connector: Mini Tamiya style |
 |
Note:
The lose wires connect to the motor and the wires with mini Tamiya
connector connect to the battery - incorrect connections will permanently
damage the unit or other components |
| |
Note:
Not compatible with Sanwa/Airtronics gear (required rewiring
the connector) |
Specification:
| Voltage
: |
7.2
- 12v |
| Burst
Current : |
50A |
| Continue
Current: |
25A |
| Weight
: |
~15g |
| Package Weight : |
~35g |
|